Managed Switch Led Indicators; Configuring The Managed Ethernet Switch Module - GE UR F35 Series Instruction Manual

3.4 MANAGED ETHERNET SWITCH MODULES
The wiring for the managed Ethernet switch module is shown below.
3
The 10/100Base-T and 100Base-FX ports have LED indicators to indicate the port status.
The 10/100Base-T ports have three LEDs to indicate connection speed, duplex mode, and link activity. The 100Base-FX
ports have one LED to indicate linkup and activity.
A suitable IP/gateway and subnet mask must be assigned to both the switch and the UR relay for correct operation. The
Switch has been shipped with a default IP address of 192.168.1.2 and a subnet mask of 255.255.255.0. Consult your net-
work administrator to determine if the default IP address, subnet mask or default gateway needs to be modified.
3-44
Figure 3–47: MANAGED ETHERNET SWITCH MODULE WIRING
Figure 3–48: ETHERNET SWITCH LED INDICATORS

3.4.4 CONFIGURING THE MANAGED ETHERNET SWITCH MODULE

Do not connect to network while configuring the switch module.
F35 Multiple Feeder Protection System

3.4.3 MANAGED SWITCH LED INDICATORS

Connection speed indicator (OFF = 10 Mbps; ON = 100 Mbps)
Link indicator (ON = link active; FLASHING = activity)
Duplex mode indicator (OFF = half-duplex; ON = full-duplex)
Link indicator (ON = link active; FLASHING = activity)
3 HARDWARE
842868A2.CDR
GE Multilin