Sub Trim; Sub Trm - FUTABA 6k Instruction Manual

Sub trim

SUB TRM

Function
The Sub-Trim function is used to set the servo
neutral position, and may be used to make fine
adjustments to the control surface after linkages
and pushrods are hooked up. When you begin to set
up a model, be sure that the digital trims are set to
their center position.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
（1 second）
● Select the channel with the
Jog key.
＜ ChannelDisplay ＞
AIRPLANE (2AIL1FLP)
1: AI1（Aileron1）
2: ELE（Elevator）
3: THR（Throttle）
4: RUD（Rudder）
5: FLP（Flap）
6: AI6（Aileron6）
Sub trim
① Select the SUB trim you want to set from
channel item and set the rate by pressing
the + key or – key.
＋
or
② Select
from the menu with the Jog
key.
SUB trim rate of the selected channel.
HELICOPTER
1: AIL（Aileron）
2: ELE（Elevator）
3: THR（Throttle）
4: RUD（Rudder）
5: GYR（GYRO）
6: PIT（Pitch）
－
● When you want to
Setting precautions
If sub trim is too large, the servo operating range
may be exceeded at maximum control surface
angle and generate a dead band in which the servo
does not operate. First connect the linkage so that
the amount of sub trim used is held to a minimum.
"SUB TRM"
GLIDER (2AIL2FLP)
1: AI1（Aileron1）
2: ELE（Elevator）
3: FL3（Flap3）
4: RUD（Rudder）
5: FL5（Flap5）
6: AI6（Aileron6）
Range：
-120 ～ +120%
Default：0%
return the set value
to the initial value,
press the + key and –
key simultaneously.
(Common)
③ Open the setting screen by
pressing the Jog key.
● SUB trim rate of each channel.
MULTICOPTER
1: AIL（Aileron）
2: ELE（Elevator）
3: THR（Throttle）
4: RUD（Rudder）
5: AUX
6: MOD（Mode）
61