Table of Contents
Advertisement
Snap Roll
This function selects the switch and rate
adjustment of rudder, ailerons, elevators, or flaps
when a snap roll is performed.
right/down, left/up, left/down)
switch in the state in which the direction switch
was switched to the direction in which you want
roll in each direction can be executed by means
of independent switches.
the switch can be set so that snap roll is not
executed when, for instance, the landing
gear is lowered, even if the switch is turned on
accidentally. The snap roll switch is activated only
(Single/Fine tuning/All Cond.)
106
<Model Menu (Airplane/Glider Functions)>
executing snap roll)
*The snap roll up side left and right and down side left and right
direction switches are selected here.
The operation speed of each control
be changed and snap roll executed by
stick while there is switch operation can be
performed.
below.
(For a description of the setting method, see the description at the back of this manual.)
(Gr./Sngl)
(For more information, see the description
at the back of this manual.)
Advertisement
Table of Contents
