Warning System; Cases Indicated By Error Messages - Panasonic AU-EVA1E Operating Instructions Manual

Warning system

When an error is detected right after the camera is turned on or during the operation, occurrence of error is notified in the HOME screen, VIEW screen,
or by the tally lamp. Deal with the error by following the indications.

Cases indicated by error messages

System error
Screen display
VIEW screen
[SYSTEM ERROR]
Warning
Screen display
VIEW screen
[LOW BATTERY]
[HIGH TEMPERATURE]
[REC WARNING]
[REC WARNING]
[CARD ERROR <SLOT 1>]/
[CARD ERROR <SLOT 2>]
[END]
(SD card status display)
(Once every second, flash in red)
SD card remaining recordable
capacity display
(Flashes once every second
during recording)
Chapter 9 Notes — Warning system
HOME screen
— An error in the standard signal or communication
error has occurred.
HOME screen
— Remaining battery capacity is insufficient.
— Displayed when the internal temperature of the
camera has risen above assumed.
An error of the recording data has occurred during
recording, and the recording has stopped.
It has tried to record exceeding the maximum
number of clips during recording.
A data error caused by the SD card has occurred
during recording or playback.
— The remaining recordable capacity of the SD card
has exhausted during recording.
— Battery is almost consumed.
— The remaining recordable capacity of the SD is
getting low.
Description
Description
– 161 –
Behavior and cause
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
f Set the power to < > (standby).
Behavior and cause
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
The power status display becomes
flash once every second in red.
f The power is turned off in approximately five
seconds.
f Replace with a fully charged battery, or connect
the AC adaptor.
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
f The power is turned off in approximately five
seconds.
f Turn on the power again and check recording
and playback operations. If the problem persists,
consult the dealer.
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
f Recording is stopped.
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
f Recording is stopped.
f When [DIAGNOSTICS] is selected in the INFO
screen, [REC WARNING] [<OVER MAX NUM. OF
CLIPS>] is displayed in the warning display area.
f Replace the SD card or delete unnecessary clips.
f When it was recording
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an
alarm is sounded.
Recording is stopped.
After the recording is stopped, the SD card where
the error has occurred is write protected. Replace
the SD card in the card slot where the error
occurred.
f When it was playing back
Playback is stopped.
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
f Recording is stopped.
f Replace the SD card or delete unnecessary clips.
All the tally lamps will flash once every second.
f The current operation will continue.
f Replace with a fully charged battery, or connect
the AC adaptor.
f Recording will continue.
f Replace the SD card as necessary.
, and it will