Table of Contents
Advertisement
Message
Screen display
VIEW screen
[CANNOT PLAY.]
[CANNOT DELETE.]
[CANNOT RECORD. THE
NUMBER OF CLIPS HAS
EXCEEDED THE MAXIMUM
LIMIT.]
[CARD ERROR. PLEASE
REFORMAT.]
[Repair failed.]
[UNABLE TO FORMAT.]
[CANNOT REPAIR CONTROL
INFORMATION DUE TO LOW
BATTERY POWER.]
[CANNOT PROTECT.]
[THE CLIP IS PROTECTED.
PLEASE CANCEL
PROTECTION.]
[CANNOT DELETE UNTIL TOP
MENU IS DELETED. DELETE
TOP MENU? (RECORDED DATA
WILL NOT BE DELETED)]
[CANNOT RECORD UNTIL TOP
MENU IS DELETED. DELETE
TOP MENU? (RECORDED DATA
WILL NOT BE DELETED)]
[THUMBNAIL DATA ERROR IS
DETECTED.]
[CANNOT RECORD -
INCOMPATIBLE CONTROL
DATA.]
[CANNOT SET.]
[THIS CLIP CANNOT BE
COPIED.]
[CONTROL DATA ERROR HAS
BEEN DETECTED. (SD CARD)]
[COPY FAILED. PLEASE CHECK
THE CARD.]
[COPY TERMINATION
IN PROGRESS DUE TO
INSUFFICIENT BATTERY
POWER. DO NOT SWITCH OFF.]
[COPY TERMINATED DUE
TO INSUFFICIENT BATTERY
POWER.]
[CANNOT COPY - THE NUMBER
OF CLIPS HAS REACHED
MAXIMUM.]
[LOW BATTERY. PLEASE
CONNECT AC ADAPTOR OR
CHANGE BATTERY.]
[CANNOT PLAY THIS CLIP ON
THIS MODEL.]
[Cannot copy: contains recordings
from other devices.]
Chapter 9 Notes — Warning system
HOME screen
—
This is a clip that cannot be played back.
(When it cannot be played back due to difference of
the system frequency, etc.)
An error has occurred during playback, and the
playback has stopped.
—
This is a clip that cannot be deleted.
—
The number of clips that can be recorded has
reached the maximum.
—
Formatting of the SD card has failed.
—
Repairing of the clip that an error has occurred
has failed due to disconnection of the power or
removing of the SD card during recording.
Restoring of the management information has
failed.
—
This is an SD card that cannot be formatted.
—
Management information cannot be restored due to
insufficient remaining battery capacity.
—
This is a clip that cannot be protected.
—
The clip is protected so it cannot be deleted.
—
It is trying to delete a clip on the SD card where the
top menu is created.
—
The SD card with top menu created is inserted.
—
An error occurred in the thumbnail information of
the SD card.
—
Version of the management information of the SD
card is not supported.
—
This cannot be set.
—
The clip cannot be copied.
—
An error occurred in the management information of
the SD card.
—
Copying of the clip has failed due to an error in the
SD card.
—
Remaining battery capacity became low while
copying the clip.
—
Copying of a clip is cancelled due to insufficient
remaining battery capacity.
—
The number of clips that can be copied has reached
the maximum.
—
It is trying to copy a clip or update the camera
firmware while the remaining battery capacity is
insufficient.
—
This is a clip that cannot be played back with the
camera.
—
The clip recorded in other device cannot be copied.
Description
– 163 –
Behavior and cause
A message is displayed.
f Confirm if the system frequency of the clip is the
same as the system frequency of the camera.
f Check the clip.
A message is displayed.
f Match the device and content versions.
A message is displayed.
f Replace the SD card or delete unnecessary clips.
A message is displayed.
f Format it again.
A message is displayed.
f Check the SD card.
A message is displayed.
f Check the SD card.
A message is displayed.
f Replace with a fully charged battery, or connect
the AC adaptor.
A message is displayed.
f Match the device and content versions.
A message is displayed.
f Cancel the protect on the clip.
A message is displayed.
f Delete the top menu.
A message is displayed.
f Delete the top menu.
A message is displayed.
f Restoring of the management information is
performed automatically after this.
A message is displayed.
f Match the device and content versions.
A message is displayed.
f Perform the setting after making it possible to set.
A message is displayed.
f Copy the clips other than the corresponding clip.
A message is displayed.
f Restoring of the management information is
performed automatically after this.
A message is displayed.
f Check the SD card.
A message is displayed.
f The copy is cancelled.
f Replace with a fully charged battery, or connect
the AC adaptor.
A message is displayed.
f Replace with a fully charged battery, or connect
the AC adaptor.
A message is displayed.
f Replace the SD card or delete unnecessary clips
in the copy destination.
A message is displayed.
f Replace with a fully charged battery, or connect
the AC adaptor.
A message is displayed.
f Playback on a device that can playback.
A message is displayed.
f Copy the clips other than the corresponding clip.
Advertisement
Table of Contents
