Panasonic AU-EVA1E Operating Instructions Manual page 94

Memory card camera-recorder
Table of Contents

Advertisement

[PEAKING LEVEL]
Sets the intensity of the peaking display.
The items that can be set are as follows.
f [LOW], [MID], [HIGH]
(Factory setting: [MID])
[PEAKING COLOR]
Sets the color of the peaking display.
The items that can be set are as follows.
f [RED], [GREEN], [WHITE]
(Factory setting: [RED])
[BLACK & WHITE]
Enables/disables the monochrome display.
[ON]
[OFF]
[DURING PEAK./SQUARES]
(Factory setting: [OFF])
[OPEN IRIS MODE]
Sets the time for the open iris focus assist function is to operate. The open iris focus assist function is forced to cancel when the recording is started.
The items that can be set are as follows.
f [10SEC], [30SEC]
(Factory setting: [10SEC])
[LCD EI ASSIST]
[ZEBRA]
Sets if the zebra signal is superimposed or not to the output from the <LCD> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[ZEBRA1 DETECT]
Sets the detection level of zebra pattern 1.
The items that can be set are as follows.
f [0%]...[109%]
(Factory setting: [80%])
[ZEBRA2 DETECT]
Sets the detection level of zebra pattern 2.
The items that can be set are as follows.
f [0%]...[109%]
(Factory setting: [100%])
[ZEBRA2]
Enables/disables zebra pattern 2 and selects [SPOT].
The items that can be set are as follows.
f [ON], [SPOT], [OFF]
(Factory setting: [OFF])
[WFM MODE]
Sets the display of the waveform monitor. Displaying of the waveform and the vector can be switched.
[WAVE]
[VECTOR]
[WAVE/VECTOR]
(Factory setting: [WAVE])
[WFM TRANSPARENCE]
Sets the transmittance of the waveform monitor.
The items that can be set are as follows.
f [0%], [25%], [50%]
(Factory setting: [50%])
Chapter 4 Operation — Menu setting contents
Enables the monochrome display.
Disables the monochrome display.
The monochrome display is enabled while the peaking display and the focus square display is enabled.
Displays the waveform.
Displays the vector.
Displays the waveform and the vector.
It will switch in the order of waveform, vector, and no display every time the USER button with [WFM] assigned is pressed.
– 94 –

Advertisement

Table of Contents
loading

Table of Contents