Table of Contents
Advertisement
[INPUT1 MIC POWER]
Enables/disables the phantom power supply for the external microphone connected to the <AUDIO INPUT 1> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[INPUT2 MIC POWER]
Enables/disables the phantom power supply for the external microphone connected to the <AUDIO INPUT 2> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[INPUT1 MIC LEVEL]
Sets the input level of the external microphone connected to the <AUDIO INPUT 1> terminal. Enabled when the external microphone is connected and
[INPUT1 LINE/MIC SEL] of [AUDIO INPUT] is set to [MIC].
The items that can be set are as follows.
f [-40dB], [-50dB], [-60dB]
(Factory setting: [-60dB])
[INPUT2 MIC LEVEL]
Sets the input level of the external microphone connected to the <AUDIO INPUT 2> terminal. Enabled when the external microphone is connected and
[INPUT2 LINE/MIC SEL] of [AUDIO INPUT] is set to [MIC].
The items that can be set are as follows.
f [-40dB], [-50dB], [-60dB]
(Factory setting: [-60dB])
[INPUT1 LINE LEVEL]
Sets the audio input level of the audio device connected to the <AUDIO INPUT 1> terminal. Enabled when the audio device is connected and [INPUT1
LINE/MIC SEL] of [AUDIO INPUT] is set to [LINE].
The items that can be set are as follows.
f [4dB], [0dB]
(Factory setting: [4dB])
[INPUT2 LINE LEVEL]
Sets the audio input level of the audio device connected to the <AUDIO INPUT 2> terminal. Enabled when the audio device is connected and [INPUT2
LINE/MIC SEL] of [AUDIO INPUT] is set to [LINE].
The items that can be set are as follows.
f [4dB], [0dB]
(Factory setting: [4dB])
[AUDIO OUTPUT]
[MONITOR OUT]
Sets the audio channel and the format to be output from the headphone terminal.
[CH1]
[CH2]
[STEREO]
[MIX]
(Factory setting: [STEREO])
[MONITOR DELAY]
Sets if the audio from the headphone terminal is to be delayed to match the video on the LCD monitor.
[LIVE]
[RECORDING]
(Factory setting: [LIVE])
[MONITOR VOL]
Adjusts the level of audio output from the headphone terminal.
The items that can be set are as follows.
f [0]...[100]
(Factory setting: [70])
[REC BEEP SOUND]
[MODE]
Sets if the beep sound is generated when starting or stopping the recording.
[OFF]
Chapter 4 Operation — Menu setting contents
Outputs the signal for audio channel 1 as monaural.
Outputs the signal for audio channel 2 as monaural.
Outputs the signals of the audio channel 1 and the audio channel 2 as stereo.
Mixes the signals of the audio channel 1 and the audio channel 2 and outputs as monaural.
Outputs without delay.
Matches to the video on the LCD monitor.
The beep sound is not generated.
– 85 –
Advertisement
Table of Contents
