Table of Contents
Advertisement
Minute
Second
Frame
(Factory setting: [00]) (each item)
[SET UB]
Sets user bits.
Enabled only when [USER] is selected in [UB MODE] of [TC].
Each digit can be set in following range.
f [00]...[FF]
(Factory setting: [00])
[TC/UB/Dur.]
Switches the time code display to the user bits or duration counter display.
The items that can be set are as follows.
[TC]
[UB]
[Dur.]
(Factory setting: [TC])
[FREE/REC RUN]
Sets the operation mode to advance the time code generator.
[FREE RUN]
[REC RUN]
(Factory setting: [FREE RUN])
@
NOTE
t It will be fixed to [REC RUN] when the [CAMERA SETTINGS] menu → [FPS] → [VFR SW] → [ON] is set.
t It will be fixed to [FREE RUN] when the [REC SETTINGS] menu → [PRE REC] → [ON] is set.
[DF/NDF]
Sets the count method for the time code generator.
Enabled only when the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [FREQUENCY] → [59.94i]/[59.94p]/[29.97p] is set.
[DF]
[NDF]
(Factory setting: [NDF])
[UB MODE]
Selects the user bits mode. User bits information is recorded in the clip. Also, it is output as LTC UB, VITC UB of the SDI signal.
[FRAME RATE]
[USER]
[TIME]
[DATE]
[CLIP NAME]
(Factory setting: [USER])
[TC IN/OUT SEL]
Sets the input/output of the <TC IN/OUT> terminal.
[TC IN]
[TC OUT]
(Factory setting: [TC IN])
[TC OUT REF]
Sets the output delay of the time code that is output from the <TC IN/OUT> terminal.
[RECORDING]
[SDI OUT]
(Factory setting: [RECORDING])
Chapter 4 Operation — Menu setting contents
[00]...[59]
[00]...[59]
[00] ... [23] (when [24.00p] or [23.98p] is set)
[00] ... [24] (when [50.00i], [50.00p], or [25.00p] is set)
[00] ... [29] (when [59.94i], [59.94p], or [29.97p] is set)
Time code display
User bits display
Duration counter display
Advances regardless of the operation mode.
Advances only while recording.
Uses the drop frame mode.
Uses the non-drop frame mode.
Selects the image information (such as frame rate) of the camera.
Selects the user bits set in [SET UB].
Selects the local time. (hh, mm, ss)
Selects the local date and time. (YY, MM, DD, hh)
ASCII character code of the CAM INDEX (A to Z) recorded as a MOV format file goes into MSB. Also, three digit ASCII
character code of the REEL COUNT recorded as the MOV format file goes into LSB. (Example: A123=0x41 0x31 0x32 0x33)
It will record even if the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [MAIN CODEC] is not set to the MOV format.
Sets to the time code input.
Sets to the time code output.
Outputs the recording time code without delay. This is used when performing simultaneous recording on two cameras with
the time code of this camera as the master.
Matches to output image from the <SDI OUT> terminal. Outputs without delay when video is not output from the <SDI OUT>
terminal.
– 83 –
Advertisement
Table of Contents
