Table of Contents
Advertisement
[HLG]
(Factory setting: [V-255570L1])
[MASTER GAMMA]
Sets the master gamma in 0.01 steps.
The items that can be set are as follows.
f [0.30]...[0.75]
(Factory setting: [0.45])
[BLACK GAMMA]
Sets the gamma curves of dark areas.
The items that can be set are as follows.
[−8]...[−1]
[OFF]
[1]...[8]
(Factory setting: [OFF])
[B.GAMMA RANGE]
Sets the maximum level to perform compression/expansion of dark area.
The items that can be set are as follows.
[1]
[2]
[3]
(Factory setting: [1])
[KNEE]
[KNEE SW]
Enables/disables operation of the knee.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [ON])
[KNEE MODE]
Sets the knee operation mode.
[D RANGE]
[PRESS]
(Factory setting: [D RANGE])
[KNEE POINT]
Sets the position of the knee point.
The items that can be set are as follows.
f [55%] ... [100%] (1% steps)
(Factory setting: [85%])
[KNEE SLOPE]
Sets the knee inclination.
The items that can be set are as follows.
f [0]...[100]
(Factory setting: [100])
[HLG KNEE]
[KNEE SW]
Enables/disables the operation of knee for HLG.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
Chapter 4 Operation — Menu setting contents
A hybrid log gamma (HLG) curve.
Compresses the dark area.
Standard condition.
Expands the dark area.
Around 20%
Around 30%
Around 40%
The dynamic range that can be represented is determined by the value of [KNEE SLOPE] in [KNEE].
The value of dynamic range that can be represented does not change even when the value of [KNEE POINT] in [KNEE] is
changed.
The compression rate of the signal is determined by the value of [KNEE SLOPE] in [KNEE].
The value of dynamic range that can be represented will change when the value of [KNEE POINT] in [KNEE] is changed.
– 79 –
Advertisement
Table of Contents
