Installation: Pointek Cls200 Digital; Location; Mounting - Siemens Pointek CLS200 Digital Operating Instructions Manual

Installation: Pointek CLS200 Digital

Notes:
• Installation shall only be performed by qualified personnel and in accordance with
local governing regulations.
• This product is susceptible to electrostatic shock. Follow proper grounding
procedures.
• The housing may only be opened for maintenance, local operation, or electrical
installation.
• Before installing the instrument, verify that the environment complies with any
restrictions specified on the product nameplate.
• To comply with CE EMC regulations, where applicable, the CLS200 should be installed
in accordance with the testing details on page 13.

Location

Recommended:
• Provide a sun shield to protect the transmitter from direct heat radiation.
Precautions:
• Avoid mounting Pointek CLS200 in locations subject to strong vibrations in the
vicinity, whenever possible.
• Do not exceed the permissible ambient temperature limits (see
page 12 for details).

Mounting

Pointek CLS200 (compact probe)
High level alarm
vertical
normal process
level
For high level alarm (level exceeds normal process level):
• normally mounted into the vessel top, or
• mounted through the tank wall at the detection level
For low level alarm (level drops below normal process level):
• mounted through the tank wall at the detection level
7ML19985JJ03 Pointek CLS200/300 Digital – OPERATING INSTRUCTIONS
Environmental
Low level alarm
normal process
level
horizontal
on
Page 15