Installation: Pointek CLS300 Digital
Notes:
• Installation shall only be performed by qualified personnel and in accordance with
local governing regulations.
• This product is susceptible to electrostatic shock. Follow proper grounding
procedures.
• The housing may only be opened for maintenance, local operation, or electrical
installation.
• Before installing the instrument, verify that the environment complies with any
restrictions specified on the product nameplate.
• To comply with CE EMC regulations, where applicable, the CLS300 should be installed
in accordance with the testing details on page 14.
Location
Recommended:
•
Provide a sun shield to protect the transmitter from direct heat radiation.
Precautions:
•
Avoid mounting Pointek CLS300 Digital in locations subject to strong vibrations in
the vicinity, whenever possible.
•
Do not exceed the permissible ambient temperature limits (see
page 12 for details).
Mounting
Pointek CLS300 typical configuration:
High level alarm
For high level alarm (level exceeds normal process level):
•
normally mounted into the vessel top, or
•
mounted through the tank wall at the detection level
For low level alarm (level drops below normal process level):
•
mounted through the tank wall at the detection level
Page 20
Pointek CLS200/300 Digital – OPERATING INSTRUCTIONS
vertical
normal process
level
Environmental
Low level alarm
horizontal
on
normal process
level
detection level
7ML19985JJ03