Mode 16: Profibus Ident Number (Default: 1); Mode 19: 0% Application Range Setting - Siemens Pointek CLS200 Digital Operating Instructions Manual

Mode 16: PROFIBUS Ident Number
Determines which of two device operating modes to select. Pointek CLS200/300 Digital
recognizes two operating modes in relation to the DP Master:
Mode Description
0 Conforms to profile
version 3.0 Class B
device with no
extensions.
1 Conforms to profile
version 3.0 Class B
device with
extensions.
To set the device operating mode:
• Select Mode 16. The current device operating Mode (0 or 1) appears in the
primary reading field.
Press ⇑ or ⇓ to select the desired operating mode.
•
• Press M to save the selection and exit.

Mode 19: 0% Application Range setting

This point corresponds to the left limit of the bar graph in the digital display.
CLS200 0% Application Range setting
To adjust the 0% Application Range setting for CLS200:
1. Install the device in the process.
2. Use the M button to navigate to Mode 19.
3. Set up the process to provide the recommended condition for your process from the
table below:
Application
General
Demanding
Interface
detection
1.
Applies to PROFIBUS PA applications only. If in standalone application (no network), leave
the node address at the default value.
Page 40 Pointek CLS200/300 Digital – OPERATING INSTRUCTIONS
Generic: can substitute transmitters conforming to
PROFIBUS PA profile 3.0, one Discrete Input
Function Block.
Device-Specific: full functional range of
Pointek CLS200/300 with Discrete Input Function
Block.
Material
• dry solids
• low viscosity liquids
• hygroscopic / wet solids
• high viscosity and high
conductivity liquids
• liquid A / liquid B
• foam / liquid
1
(default: 1)
Setup conditions
sensor uncovered;
min. 100 mm (4") free space all around
sensor immersed then uncovered; but
retaining max. possible material buildup
sensor immersed in the material with
the lowest dielectric constant
7ML19985JJ03