Viewing And Editing Classifier Configuration - ZyXEL Communications XGS3700-48 User Manual

Table 86 Advanced Application > Classifier > Classifier Configuration (continued)
LABEL
Add
Cancel
Clear

19.3.1 Viewing and Editing Classifier Configuration

To view a summary of the classifier configuration, scroll down to the summary table at the bottom
of the Classifier screen. To change the settings of a rule, click a number in the Index field.
Note: When two rules conflict with each other, a higher layer rule has priority over a lower
layer rule.
Figure 140 Advanced Application > Classifier > Classifier Configuration: Summary Table
The following table describes the labels in this screen.
Table 87 Advanced Application > Classifier > Classifier Configuration: Summary Table
LABEL
Index
Active
Weight
Name
Rule
Delete
Cancel
The following table shows some other common Ethernet types and the corresponding protocol
number.
Table 88 Common Ethernet Types and Protocol Number
ETHERNET TYPE
IP ETHII
X.75 Internet
NBS Internet
ECMA Internet
Chaosnet
Chapter 19 Classifier
DESCRIPTION
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to set the above fields back to the factory defaults.
DESCRIPTION
This field displays the index number of the rule. Click an index number to edit the rule.
This field displays Yes when the rule is activated and No when it is deactivated.
The field displays the priority of the rule when the match order is in manual mode. A higher
weight means a higher priority.
This field displays the descriptive name for this rule. This is for identification purposes only.
This field displays a summary of the classifier rule's settings.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the table
heading row to select all entries.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the check boxes.
PROTOCOL NUMBER
0800
0801
0802
0803
0804
GS3700/XGS3700 Series User's Guide
206