ABB AX410 User Manual page 17

Single and Dual Input Analyzers for Low Level Conductivity
AX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456
Power
Errors
Alarms
----- Cals
VIEW LOGBOOK
1
Sen.A
-----
User
Calibration
0. 9 69
Slope
0. 0 16
uS/cm
05:02:04 11:14
VIEW CLOCK
SENSOR CAL.
SECURITY CODE
CONFIG. DISPLAY
IM/AX4CO Issue 11
View Logbook
Use the and
Note. If no entries are stored in the
Calibration
The logbook contains up to 5 entries (entry 1 is the most recent), each comprising 2
Cals
frames. Frame 1 contains the entry number and sensor letter and shows User to indicate a
user performed calibration.
Frame 2 contains either the the sensor % slope and sensor offset values (for a conductivity
calibration), or the temperature % slope and temperature offset values (for a temperature
calibration), together with the date/time of the calibration.
Note. If no more entries are stored, the display shows No More Entries.
Option board fitted and analog features enabled (Section 7.3) - see section 3.6, page 16.
set to
Enable Cals.
set to
Enable Cals.
section 5.1, page 19.
set to
Enable Cals.
5.2, page 20.
Advance to entries 2 to 5.
2 Sen.A
Note. If no more entries are stored, the display shows No More Entries.
keys to access the
logbook, the display shows No More Entries.
Cals
(Section 5.3) - see section 4.1, page 17.
Yes
(Section 5.3) and
No Alter Sec. Code
(Section 5.3) and
No Alter Sec. Code
3 OPERATOR VIEWS
logbook.
Cals
not set to zero (Section 5.9) - see
set to zero (Section 5.9) - see section
15