View Outputs - ABB AX410 User Manual

Single and Dual Input Analyzers for Low Level Conductivity
AX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456

3.2 View Outputs

-----
VIEW OUTPUTS
12. 0 0
mA
50. 0 %
Analog Output 1
10
Theoretical Analog Output
There are up to four analog outputs, each showing information for one sensor.
Note. Analog outputs 3 and 4 available only if option board fitted and analog features
enabled - see section 7.3, page 62.
Live current output value being retransmitted.
Current output shown as a percentage of full scale for the output range set in
- see section 5.5, page 34.
OUPUTS
See Section 3.3.
VIEW HARDWARE
set to
SENSOR CAL. Enable Cals.
set to
SECURITY CODE Enable Cals.
see section 5.1, page 19.
set to
CONFIG. DISPLAY Enable Cals.
section 5.2, page 20.
Advance to analog output 2 (and outputs 3 and 4 if option board fitted and analog
Analog Output 2
features enabled - see section 7.3, page 62).
(Section 5.3) - see section 4.1, page 17.
Yes
(Section 5.3) and
No Alter Sec. Code
(Section 5.3) and
No Alter Sec. Code
3 OPERATOR VIEWS
CONFIG.
not set to zero (Section 5.9) -
set to zero (Section 5.9) - see
IM/AX4CO Issue 11