Dual Input Conductivity - ABB AX410 User Manual

Single and Dual Input Analyzers for Low Level Conductivity
AX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456

2.3.2 Dual Input Conductivity

0. 8 83
uS/cm
0. 8 92
uS/cm
Dual Cond.
0. 8 86
uS/cm
0. 8 95
uS/cm
@ 25 Deg.C
25. 6
Deg.C
24. 4
Deg.C
Temperature
Dual Cond.
IM/AX4CO Issue 11
Measured Conductivity
Sensor A.
Sensor B.
Notes.
•
Dual Cond.
page 21. See below for an explanation of calculations.
• The displayed conductivity readings are the actual values of the sample.
• AX455 analyzers only - If
displayed conductivity reading for that sensor is the uncompensated conductivity
value of the sample, i.e. its value at its measured temperature (see below).
Temperature Compensated Conductivity - AX455 Analyzers Only
Sensor A.
Sensor B.
Notes.
• This frame is displayed only if
- see section 5.3, page 21.
• If
Cond.Units
reading for that sensor is the temperature compensated value, i.e. the value it
would be at a sample temperature of 25ºC (77ºF).
Measured Temperature
Sensor A.
Sensor B.
Note. The displayed temperature readings are the actual values of the sample.
See Section 3.1.
VIEW SETPOINTS
set to
Enable Cals.
SENSOR CAL.
set to
Enable Cals.
SECURITY CODE
see section 5.1, page 19.
set to
CONFIG. DISPLAY Enable Cals.
section 5.2, page 20.
is displayed only if
Signal Calc.
for a sensor is set to
Cond.Units
Cond.Units
for a sensor is set to
USP645
(Section 5.3) - see section 4.1, page 17.
Yes
(Section 5.3) and
No Alter Sec. Code
(Section 5.3) and
No Alter Sec. Code
2 OPERATION
is set to - see section 5.3,
No Calculation
(Section 5.3), the
USP645
for either or both sensors is set to
(Section 5.3), the displayed conductivity
not set to zero (Section 5.9) -
set to zero (Section 5.9) - see
USP645
7