ABB AX410 User Manual page 39

Single and Dual Input Analyzers for Low Level Conductivity
AX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456
Off
On
-----
Hold
mA
AO1: Default O/P
Config. Output 1
Off or Hold
On
12. 0 0
mA
AO1: Default Val
Config. Output 1
IM/AX4CO Issue 11
Default Output
Select the system reaction to failure:
Off
On
Hold
Default Value
The level to which the analog output is driven if a failure occurs.
Set the value between 0.00 and 22.00mA.
Output 2 configuration (and Outputs 3 and 4 if option board fitted and analog features
Config. Output 2
enabled - see section 7.3, page 62) is identical to Output 1 configuration.
Option board fitted and analog features enabled (Section 7.3) - see section 5.7, page
CONFIG. CLOCK
41.
Option board fitted and Serial Communications feature enabled (Section 7.3) - see
CONFIG. SERIAL
Supplementary Manual PROFIBUS Datalink Description (IM/PROBUS).
Single input analyzer and option board not fitted - see section 5.8, page 42.
CONFIG. CONTROL
Dual input analyzer and option board not fitted - see section 5.9, page 47.
CONFIG. SECURITY
- Ignore failure and continue operation.
- Stop on failure. This drives the analog output to the level set in the
frame below.
Default Val
- Hold the analog output at the value prior to the failure.
5 PROGRAMMING
37