ABB AX410 User Manual page 7

Single and Dual Input Analyzers for Low Level Conductivity
AX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456
Use the Menu Key
to scroll through
the Menus
Section 5.5, Page 34
CONFIG.OUTPUTS
Use the Downscroll
Key to scroll through
the Frames
within each Page
Section 5.7, Page 41
CONFIG.CLOCK
Press
CONFIG.SERIAL
Section 5.8, Page 42
CONFIG. CONTROL
Section 5.9, Page 47
CONFIG.SECURITY
Section 5.10, Page 47
CONFIG.LOGBOOK
Section 5.11, Page 48
TEST/MAINTENANCE
To
FACTORY SETTINGS
(see Section 7.3, Page 62)
Fig. 2.4 Overall Programming Chart
IM/AX4CO Issue 11
Use the Sidescroll Key to scroll through the Pages within each Menu
Config. Output 1 Config. Output 2
AO1: Assign AO2: Assign
AO1: Range AO2: Range
AO1: Curve AO2: Curve
AO1: Span Value AO2: Span Value
AO1: Zero Value AO2: Zero Value
AO1: Set X Value AO2: Set X Value
AO1: Set Y Value AO2: Set Y Value
AO1: Default O/P AO2: Default O/P
AO1: Default Val AO2: Default Val
Set Clock?
Format dd/mm/yy
Date 01:01:02
Time 12:00
To Set Press To Abort
Displayed only if Option Board fitted and Serial Communications feature enabled (Section 7.3) —
see Supplementary Manual PROFIBUS Datalink Description (IM/PROBUS)
Controller PID Controller
Control Action
Prop. Band
Integral time
Derivative time
Output Type
Pulses/Minute
OR
Cycle Time
OR
Output Range
Alter Sec.Code
Alter Cal.Code
Logbook
Test Outputs
Maintenance
Test Output 1 Hold Outputs
Test Output 2 Automatic Time
Test Output 3
Press
Test Output 4
Config. Output 3 Config. Output 4
AO3: Assign AO4: Assign
AO3: Range AO4: Range
AO3: Curve AO4: Curve
AO3: Span Value AO4: Span Value
AO3: Zero Value AO4: Zero Value
AO3: Set X Value AO4: Set X Value
AO3: Set Y Value AO4: Set Y Value
AO3: Default O/P AO4: Default O/P
AO3: Default Val AO4: Default Val
Power Recovery
Power Rec. Mode
Default Output
Key
Load/Save Config
Factory Config.
User Config.
To Set Press To Abort
2 OPERATION
Single input analyzer only
Available only if the option board is fitted and
analog features enabled — see Section 7.3
5