ABB AX410 User Manual page 51

Single and Dual Input Analyzers for Low Level Conductivity
AX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456
Hold Outputs
set to
Auto.
1 Hrs
30
Mins
Automatic Time
Maintenance
Yes
No
-----
Load/Save Config
Yes
Load
Save
-----
User Config.
Factory Config.
-----
Press To Set.
Press To Abort
TEST/MAINTENANCE
IM/AX4CO Issue 11
Automatic Time
If required, set a time period between 1 and 6 hours, in 30 minute increments, for which
the outputs are held when
At the default setting of
during sensor calibration and enabled automatically at the end of the procedure.
If a time is set, changes in relay action and analog outputs are disabled during sensor
calibration, but if the calibration is not completed within the set time, the calibration is
aborted, the display returns to the Operating Page and
Continued below.
Load/Save Config
See Section 7.3.
FACTORY SETTINGS
Load/Save Configuration
Select whether a configuration is to be loaded or saved.
Note. If is selected, pressing the
No
Return to main menu.
TEST/MAINTENANCE
See Section 7.3.
FACTORY SETTINGS
Load User/Factory Configuration
Note. Applicable only if
Factory Config.
Save User Config.
Load User Config.
and
User Config.
been saved previously. Use the and keys to make the required selection.
Press to Set
display line.
Press the appropriate key to load/save the configuration or abort the changes.
is set to
Hold Outputs
, changes in relay action and analog outputs are disabled
None
key has no effect.
is set to
Load/Save Config
- resets all the parameters in the
to the Company Standard.
- saves the current configuration into memory.
- reads the saved user configuration into memory.
are displayed alternately if a User Configuration has
Factory Config.
and are displayed alternately on the lower
Press to Abort
5 PROGRAMMING
.
Auto
is displayed.
CAL. ABORTED
.
Yes
Configuration Pages
49