Operating Page - ABB 4630 Operating Instructions Manual

...6 OPERATION

6.2.1 Operating Page

.
7 0 0
Monitoring pH
WASH IN PROCESS
Press to advance
to next page
or
Press to advance
to next parameter
2 5 0 .
Temperature (°C)
or
2 0 0 .
Preset Temp (°C)
2 5 0
Millivolts
.
l 0 5 0
Alarm 1 Setpoint
.
3 5 0
Alarm 2 Setpoint
14
Measured pH
The measured pH is displayed.
If the Water Wash cycle is selected (Models 4631 or 4636 only), an alternative message,
WASH IN PROCESS, is displayed. The Alarm 1 status and the retransmission value
are held in their pre-cycle condition for the duration of the wash cycle.
– – – – –
pH CALIBRATION
These two keys are used to advance to all subsequent parameters and pages.
Sample Temperature:
Automatic
is displayed in either °C or °F. The display units are programmable – see Section 7.3,
Mode
Up Parameters Page
Parameters Page
Preset Temperature:
Manual
value is displayed in either °C or °F. The display units are programmable – see Section
Mode
7.3,
Set Up Parameters Page
Parameters Page
Measured Millivolts
The sensor reading is displayed in millivolts.
Alarm 1 Set Point
The set point value and relay/l.e.d. action are programmable – see Section 7.4,
.
Alarms Page
Note. This display is bypassed if Alarm 1 Type has been set to Fail or Off –
see Section 7.4,
Alarm 2 Set Point
The set point value and relay/l.e.d. action are programmable – see Section 7.4,
.
Alarms Page
Note. This display is bypassed if the
2 Type has been set to Fail or Off – see Section 7.4,
Continued on next page.
. Automatic or manual mode is also selected in the
.
. The preset temperature value is also set in the
.
.
Set Up Alarms Page
sequence is selected or if Alarm
Water Wash
Set Up Alarms Page
Set
Set Up
Set Up
Set Up
Set Up
.