Configure Outputs - ABB AX410 User Manual

Single and Dual Input Analyzers for Low Level Conductivity
AX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456

5.5 Configure Outputs

-----
CONFIG. OUTPUTS
-----
Config. Output 1
% Pass
Temp.B
Sen.B
Temp.A
----- Sen.A
AO1: Assign
34
Configure Output 1
Output 2 configuration (and Outputs 3 and 4 if option board fitted and analog features
Config. Output 2
enabled - see section 7.3, page 62) is identical to Output 1 configuration.
Assign
Select the sensor and analog output required:
Sen.A
Sen.B
Temp.A
Temp.B
Notes.
• Sen.B and Temp.B are applicable only to dual input analyzers.
• If
Signal Calc.
Calculation
% Pass
% Rej
A - B
A/B
pH
Continued on next page.
AO1: Range
- Conductivity for the selected sensor.
- Temperature for the selected sensor.
(dual input analyzers only) is set to any parameter other than
(page 28), the selected parameter is displayed:
- set to
Signal Calc. % Passage
- set to
Signal Calc. % Rejection
- set to
Signal Calc. Difference A - B
- set to
Signal Calc. Ratio A/B
- set to
Signal Calc. Inf.pH(NH3)
(see Appendix A.3 for further information on inferred pH)
5 PROGRAMMING
, or
Inf.pH(NH3+NaCl) Inf.pH(NaOH)
IM/AX4CO
No
Issue 11