Operator Views; View Set Points - ABB AX410 User Manual

Single and Dual Input Analyzers for Low Level Conductivity
AX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456

3 OPERATOR VIEWS

3.1 View Set Points

-----
VIEW SETPOINTS
Sen.A
8. 3 00 uS/cm
A1: Setpoint
Temp.A
35. 0 Deg.C
A2: Setpoint
Sen.B
3. 5 00 uS/cm
A3: Setpoint
Temp.B
55. 0
Deg.C
A4: Setpoint
-----
Off
A5: Setpoint
VIEW SETPOINTS
IM/AX4CO Issue 11
View Set Points
This page shows alarm set points. The value of each of the set points is shown,
together with the name of the parameter it's assigned to.
Alarm assignments, set point values and relay/LED actions are programmable - see
section 5.4, page 30. Those shown in the following frames are examples only.
Sensor A (Conductivity), Alarm 1 Set Point
Sensor A (Temperature), Alarm 2 Set Point
Sensor B (Conductivity), Alarm 3 Set Point - Dual input analyzers only
Sensor B (Temperature), Alarm 4 Set Point - Dual input analyzers only
Note. Alarm 4 available only if option board fitted and analog features enabled - see
section 7.3, page 62.
Alarm 5 Set Point
Note. Alarm 5 available only if option board fitted and analog features enabled - see
section 7.3, page 62.
VIEW OUTPUTS
See Section 3.2.
set to
Enable Cals.
SENSOR CAL.
set to
Enable Cals.
SECURITY CODE
see section 5.1, page 19.
set to
CONFIG. DISPLAY
Enable Cals.
section 5.2, page 20.
(Section 5.3) - see section 4.1, page 17.
Yes
(Section 5.3) and
No Alter Sec. Code
(Section 5.3) and
No Alter Sec. Code
3 OPERATOR VIEWS
not set to zero (Section 5.9) -
set to zero (Section 5.9) - see
9