Dell PowerEdge M1000e Reference Manual page 88

cfgRhostsSyslogPort (Read or Write)
Description Remote syslog port number to use for writing the RAC and SEL logs to a remote syslog server.
This setting takes effect only if the cfgRhostsSyslogEnable parameter is set to 1(enabled).
10–65535
Legal Values
Default 514
cfgRhostsSyslogServer1 (Read or Write)
To store the RAC and SEL logs specify the first of three possible remote syslog servers. This property is only
Description
valid if cfgRhostsSyslogEnable is set to 1 (enabled).
Valid host name or IPv4 or IPv6 address.
Legal Values
Default <blank>
cfgRhostsSyslogServer2 (Read or Write)
To store the RAC and SEL logs Specify the second of three possible remote syslog servers. This property is
Description
only valid if cfgRhostsSyslogEnable is set to 1 (enabled).
Valid host name or IPv4 or IPv6 address.
Legal Values
Default <blank>
cfgRhostsSyslogServer3 (Read or Write)
To store the RAC and SEL logs specify the third of three possible remote syslog servers. This property is only
Description
valid if cfgRhostsSyslogEnable is set to 1(enabled).
Valid host name or IPv4 or IPv6 address.
Legal Values
Default <blank>
cfgRhostsSyslogPowerLoggingEnabled (Read or Write)
Description To remote syslog servers, Enables or disables power consumption logging.
• 1 — Enabled
Legal Values
• 0 — Disabled
0
Default
88
NOTE: The following port numbers are reserved and cannot be used: 21, 68, 69, 123, 161, 546, 801,
4096, 5988, 5989, 6900, 9000, 60106.
NOTE: Remote syslog must be enabled and more than one remote syslog servers must be configured
to log the power consumption.