•
To test LDAP.
racadm testfeature -f LDAP -u joe -p dell123 -d 0xf2
testtrap
Description
Tests the RAC's SNMP trap alerting feature by sending a test trap from CMC to a specified destination trap
listener on the network.
To run this subcommand, you must have the Test Alert permission.
racadm testtrap -i <index>
Synopsis
Input
-i <index> — Specifies the index of the trap configuration that must be used for the test. Valid values are
from 1 to 4.
•
Send a test trap to the destination configured for index 1:
Example
racadm testtrap -i 1
traceroute
Description
Traces network path of the routers as the packets traverse from the system to a destination IPv4 address.
To run this subcommand, you must have the Administrator privilege.
racadm traceroute <IPv4 address>
Synopsis
Input
IPv4 — Specifies IPv4 address.
traceroute to 192.168.0.1 (192.168.0.1), 30 hops max, 40 byte packets
Output
1 192.168.0.1 (192.168.0.1) 0.801 ms 0.246 ms 0.253 ms
traceroute6
Description
Traces the network path of routers as the packets traverse from the system to a destination IPv6 address.
To run this subcommand, you must have the Administrator privilege.
racadm traceroute6 <IPv6address>
Synopsis
Input
<IPv6address> – Specifies IPv6 address.
traceroute to fd01::1 (fd01::1) from fd01::3,
Output
30 hops max, 16 byte packets
1 fd01::1 (fd01::1) 14.324 ms 0.26 ms 0.244 ms
NOTE: Before you run the testtrap subcommand, make sure that the specified index in the
cfgAlerting group is configured properly.
77