Racadm ? And ? Subcommand - Dell PowerEdge M1000e Reference Manual

racadm ? and ? subcommand

Description Displays all the subcommands you can use with the RACADM command and a one-line description about each
subcommand.
? followed by <subcommand> displays the syntax for the specified command.
To use this subcommand, you must have the CMC Login User privilege.
You can also use the help and help <subcommand> commands to obtain the same information.
racadm ?
Synopsis
racadm ? <subcommand>
N/A
Input
N/A
Output
Example for RACADM?
The following output example shows only part of the actual output for the RACADM? command. Descriptions shown in this example
may vary slightly from the descriptions in your RACADM session.
racadm ?
help -- list racadm subcommand description
help <subcommand> -- display usage summary for a subcommand
? -- list racadm subcommand description
? <subcommand> -- display usage summary for a subcommand
arp -- display the networking arp table
chassisaction -- execute chassis or switch power-up/down/cycle or KVM powercycle
chassislog -- display chassis log management operations
closessn -- close a session
clrraclog -- clear the CMC log
clrsel -- clear the System Event Log (SEL)
cmcchangeover -- changes the redundant state of the CMC from active to standby and vice
versa
config -- modify CMC configuration properties
connect -- connect to switch or blade serial console
deploy -- deploy blade or IOM by specifying required properties
feature -- display features active on the chassis / feature deactivation
featurecard -- feature card status and list the available features
fwupdate -- update the firmware on a CMC, server, IOM inf, or KVM
getactiveerrors -- display CMC active errors
getassettag -- display asset tag
getchassisname -- get the chassisname
getconfig -- display CMC configuration properties
getdcinfo -- display general I/O module and DC configuration information
getfanreqinfo -- display fan request information for Servers and Switches
getflexaddr -- display Flexaddress enablement status for all slots and fabrics
getioinfo -- display general IO information and stack information
getkvminfo -- display the KVM module information
getled -- display the LED settings on a module
getmacaddress -- get MAC/WWN addresses
getmodinfo -- get module configuration and status information
getniccfg -- display network settings for modules
getpbinfo -- get power budget status information
getpminfo -- get power management status information
getraclog -- display the CMC log
getractime -- display the current CMC time
getredundancymode -- gets the redundancy mode of the CMC
getsel -- display records from the System Event Log (SEL)
getsensorinfo -- display system sensors
getslotname -- gets the name of the slot in the chassis
14