The configuration has initiated restoration to factory defaults.
•
Reset blade 8 configuration from CMC.
racadm racresetcfg -m server-8
The RAC configuration has initiated restoration to factory defaults.
Wait up to a minute for this process to complete before accessing the RAC again.
remoteimage
Description
Connects, disconnects, or deploys a media file on a remote server.
To run this subcommand, you must have the Configure Chassis Administrator privilege.
Synopsis
•
racadm remoteimage [-m <module> | -a]
•
racadm remoteimage -d [-m <module> | -a]
•
racadm remoteimage -s [-m <module> | -a]
•
racadm remoteimage -c [-m <module> | -a] [-u <username> -p <password> -1
<image_path>]
•
racadm remoteimage -e [-m <module> | -a] [-u <username> -p <password> -1
<image_path>]
•
-c — Connect the image.
Input
•
-d — Disconnect image.
•
-u — User name to access the network share.
•
-p — Password to access the network share.
•
-l — Image location on the network share; use single quotation marks around the location.
•
The image path can be on a Windows SMB mounted drive or a Linux or Unix NFS mounted drive.
SMB mounted path:
//<ipaddress_or_domain_name>/<share_name>/<path_to_image>
NFS mounted path:
<ipaddress>:/<path_to_image>.
The extension of <path_to_image> must be either .iso or .img.
•
-s — Display current status.
•
-e — Deploys a remote image. The first boot device is set to the shared image and the server is set to
reboot.
•
-m <module> — Specifies the server to deploy the image to one of the following:
– sever–<n>, where n=1–16
– server–<nx> where n=1–8; x=a, b, c, d (lower case)
•
-a — Applies options for slots for all present servers.
•
-u — Username
•
-p — Password
NOTE: Use a forward slash (/) when providing the image location. If backward slash (\) is used,
override the backward slash for the command to run successfully.
For example:
racadm remoteimage -c -u user -p xxx -l /\/\192.168.0/\CommonShare/
\diskette.img
NOTE: The following options only apply to connect and deploy actions
63