Changing Wheels; Rear Jacking Point For Garage Jack; Application Point For Jack Stand Or Two-Column Lift - MARUTI SUZUKI S-Cross Owner's Manual

Rear jacking point for garage jack (2)

EXAMPLE
(2)
64MS140
Application point for jack stand (3)
or two-column lift
EXAMPLE
(3)
(3)
61MM0B103
NOTICE
Never apply a garage jack to the
exhaust pipe, side under spoiler (if
equipped), engine undercover or rear
torsion beam.
NOTE:
For more details, please contact an autho-
rised Maruti Suzuki workshop.

Changing Wheels

To change a wheel, use the following pro-
cedure:
1) Remove the jack, tools and spare
wheel from the vehicle.
2) Loosen, but do not remove the wheel
nuts.
3) Jack up the vehicle (follow the jacking
instructions in this section).
WARNING
• Be sure to shift into "R" (Reverse)
when you jack up the vehicle.
• Never jack up the vehicle with the
transaxle in "N" (Neutral). Other-
wise, unstable jack may cause an
accident.
4) Remove the wheel nuts and wheel.
EMERGENCY SERVICE
EXAMPLE
(1)
(2)
(3)
(4)
5) Before installing the new wheel, clean
any mud or dirt off from the surface of
the wheel (1), hub (2), thread part (3)
and surface of the wheel nuts (4) with a
clean cloth. Clean the hub carefully; it
may be hot from driving.
6) Install the new wheel and replace the
wheel nuts with their cone shaped end
facing the wheel. Tighten each nut
snugly by hand until the wheel is
securely seated on the hub.
64MS0-74E
65J4033
8-4