Table of Contents
Advertisement
BEFORE DRIVING
NOTE:
• Even after the alarm has stopped, if you
lock the doors using the keyless entry
system transmitter, keyless push start
system remote controller or request
switch, the security system will be
rearmed.
• If you disconnect the battery while the
security system is in the armed condition
or the alarm is actually in operation, the
alarm will be re-triggered when the bat-
tery is then reconnected.
• Even after the alarm has stopped at the
end of the predetermined operation time,
it will be triggered again if any of the
doors, tailgate or engine hood is opened,
or the warning may be triggered if the
vehicle feels a shock (if the shock sen-
sor is in the enabled state), without dis-
arming the security system.
Checking whether the alarm has been
triggered during parking
If the alarm was triggered and you then
turn the ignition switch to "ON" position, or
press the engine switch to change the igni-
tion mode to "ON", the security system
indicator will blink rapidly for about 8 sec-
onds and a buzzer will beep 4 times during
this period. If this happens, check whether
the vehicle has been broken into while you
were away from it.
2-15
Security system indication
• If any of the doors are opened without
unlocking by the keyless entry system
transmitter, keyless push start system
remote controller or request switch, all
turn signal lights start to blink and the
interior buzzer beeps intermittently. After
5 seconds, the siren will sound for about
27.5 seconds. The security system indi-
cator continues to blink during this time.
• If the engine hood is opened, all turn sig-
nal lights blink, and the siren sounds for
about 27.5 seconds. The security sys-
tem indicator continues to blink during
this time.
• If the shock sensor is in enabled state
and the vehicle feels a shock higher than
the pre-warning sensitivity, the siren
sounds for about 2 seconds (pre-warn-
ing). If the vehicle feels a shock higher
than full blast warning sensitivity, siren
will sound for about 4.5 seconds (full
blast warning). The security system indi-
cator continues to blink during this time.
NOTE:
If you set the full blast warning sensitivity
higher than the pre-warning sensitivity in
the setting mode of the information display,
or the vehicle feels such shock as to be
able to trigger the full blast warning, the full
blast warning will be triggered preferen-
tially. In this case, the pre-warning will not
be triggered.
Windows
Electric Window Controls
The electric windows can only be operated
when the ignition switch is in the "ON"
position or the ignition mode is "ON".
Driver's side
EXAMPLE
(1)
(4)
(2)
(3)
64MS025
The driver's door has a switch (1) to oper-
ate the driver's window, and a switch (2) to
operate the front passenger's window or
there are switches (3), (4), to operate the
rear left and right passenger windows,
respectively.
64MS0-74E
Advertisement
Table of Contents
