Table of Contents
Advertisement
EXAMPLE
(1)
(2)
56RM07007
For maintenance-free battery (cap-less
type), you need not add water. For tradi-
tional type battery, which has water filler
caps, the level of the battery solution must
be kept between the upper level line (1)
and lower level line (2) at all times. If the
level is found to be below the lower level
line (2), add distilled water to the upper
level line (1). You should periodically check
the battery, battery terminals, and battery
hold-down bracket for corrosion. Remove
corrosion using a stiff brush and ammonia
mixed with water, or baking soda mixed
with water. After removing corrosion, rinse
with clean water.
If your vehicle is not going to be driven for
a month or longer, disconnect the cable
from the negative terminal of the battery to
help prevent discharge.
Replacement of the battery
EXAMPLE
64MM07005
NOTE:
To approach the battery, remove the suc-
tion pipe (1).
EXAMPLE
(1)
(2)
(4)
(3)
64MM07006
INSPECTION AND MAINTENANCE
To remove the battery:
1) Disconnect the negative cable (1).
2) Disconnect the positive cable (2).
3) Remove the bracket bolt (3) and
remove the bracket (4).
4) Remove the battery.
To install the battery:
1) Install the battery in the reverse order of
(1)
removal.
NOTE:
When putting the battery in the battery tray,
make sure the recess on the terminal side
bottom of the battery engages with the
convex portion of the tray.
2) Tighten the bracket bolt and battery
cables securely.
NOTE:
When the battery is disconnected, some of
the vehicle's function will be initialized and/
or deactivated.
These function are required to reset after
the battery is reconnected.
EXAMPLE
64MS176
7-18
64MS0-74E
Advertisement
Table of Contents
