Table of Contents
Advertisement
BEFORE DRIVING
EXAMPLE
(2)
(4)
64MS197
(4) Lithium disc type battery:
CR1620 or equivalent
3) Put the edge of a flat blade screwdriver
in the slot of the transmitter (2) and pry
it open.
4) Hold the cover around the electric com-
ponent (3), insert a precision screw-
driver covered with insulating tape in
the space between the cover and the
component, and then remove the com-
ponent.
5) Replace the battery (4) so its + terminal
faces the "+" mark of the transmitter.
Insert the battery all the way into the
holder.
6) Close the transmitter and install it into
the transmitter holder.
7) Close the transmitter cover, install and
tighten the screw (1).
8) Make sure the door locks can be oper-
ated with the transmitter.
2-13
9) Dispose of the used battery properly
according to applicable rules or regula-
tions. Do not dispose of lithium batter-
ies with ordinary household trash.
(3)
WARNING
Swallowing a lithium battery may
cause serious internal injury. Do not
allow anyone to swallow a lithium
battery. Keep lithium batteries away
from children and pets. If swallowed,
contact a physician immediately.
NOTICE
The transmitter is a sensitive elec-
tronic instrument. To avoid damaging
it, do not expose it to dust or mois-
ture or tamper with internal parts.
NOTE:
Used batteries must be disposed properly
according to applicable rules or regulations
and must not be disposed with ordinary
household trash.
Security System (if equipped)
The security system is armed after you
lock all doors (including the engine hood
and tailgate) by using the keyless entry
system transmitter, keyless push start sys-
tem remote controller or request switch.
Once the system is armed, any attempt to
open a door by using any other means (*)
than the keyless entry system transmitter,
keyless push start system remote control-
ler or request switch, or open the engine
hood, will cause the alarm to be triggered.
* These means include the following:
– The key
– The lock knob on a door
– The central door locking switch
Also, in case that you have set the shock
sensor to enabled state and set sensitivity
of the pre-warning function and full blast
warning function to a level other than 0, the
warning will be triggered if any attempt is
made to tamper with the vehicle. The
shock sensor can be selected to enabled
or disabled state, and sensitivity of each
warning can be adjusted as desired. To set
the shock sensor, ask your authorised
Maruti Suzuki workshop or use the setting
mode of the information display.
NOTE:
• The default setting of the shock sensor
is in the disabled state. Set to the
enabled state and adjust sensitivity of
each warning according to your prefer-
ence. For details on how to use the infor-
64MS0-74E
Advertisement
Table of Contents
