Table of Contents
Advertisement
BEFORE DRIVING
NOTE:
To identify the center seat belt buckle and
latch plate in the rear seat, "CENTER" is
marked on the buckle and latch plate of the
center lap belt. The buckles are designed
so a latch plate cannot be inserted into the
wrong buckle.
Driver's Seat Belt Reminder
EXAMPLE
(1)
64MM02012
(1) Driver's seat belt reminder light
When the driver doesn't buckle his or her
seat belt, with the ignition switch in the
"ON" position or the ignition mode "ON",
the driver's seat belt reminder light in the
instrument cluster will blink and a buzzer
will sound as a reminder to the driver to
buckle his or her sear belt. For more
details, refer to the explanation below.
If the driver's seat belt remains unbuckled
when the ignition switch is in the "ON"
position or the ignition mode is "ON", the
reminder works as follows:
2-29
1. The driver's seat belt reminder light will
come on.
2. After the vehicle's speed has reached
about 15 km/h, the driver's seat belt
reminder light will blink and a buzzer
will sound for about 95 seconds.
3. After step 2) has finished, the reminder
light will remain on until the driver's seat
belt is buckled.
If the driver has buckled his or her seat belt
and later unbuckles the seat belt, the seat
belt reminder system will be activated from
step 1) or step 2) according to vehicle's
speed. When the vehicle's speed is below
about 15 km/h, the reminder will start from
step 1). When the vehicle's speed is above
about 15 km/, the reminder will start from
step 2).
The reminder will be automatically can-
celed when the driver's seat belt is buckled
or the ignition switch is turned "OFF", igni-
tion mode is switched to "LOCK" (OFF)
position.
WARNING
It is absolutely essential that the
driver and passengers wear their seat
belts at all times. Persons who are
not wearing seat belts have a much
greater risk of injury if an accident
occurs. Make a regular habit of buck-
ling your seat belt before putting the
key in the ignition or pressing the
engine switch.
Shoulder Anchor Height Adjuster
EXAMPLE
Adjust the shoulder anchor height so that
the shoulder belt rides on the center of the
outboard shoulder. To move upward, slide
the anchor up. To move downward, slide
the anchor down while pulling the lock
knob out. After adjustment, make sure that
the anchor is securely locked.
WARNING
Be sure that the shoulder belt is posi-
tioned on the center of the outside
shoulder. The belt should be away
from your face and neck, but not fall-
ing off your shoulder. Misadjustment
of the belt could reduce the effective-
ness of the safety belt in a crash.
64MS0-74E
64J198
Advertisement
Table of Contents
