Table of Contents
Advertisement
OPERATING YOUR VEHICLE
If the MASTER WARNING indicator light
blinks and the ignition modes cannot
be selected
Your keyless push start system remote con-
troller may not be sensed as being within the
interior workable area (refer to the related
explanation in this section). Try again after
making sure you have the remote controller
with you. If the ignition modes still cannot be
selected, the battery of the remote controller
may be discharged. To be able to select an
ignition mode, you must then use the follow-
ing method:
EXAMPLE
(1)
(2)
58MST0302
1) Without depressing the brake pedal
and the clutch pedal, push the engine
switch (1).
2) The master warning indicator light in
the instrument cluster blinks and the
message
"PLACE
KEY
FOB
START SWITCH" appears on the infor-
mation display, within about 10 sec-
onds, touch the engine switch with
3-7
LOCK button end of remote controller
(2) for about 2 seconds.
NOTE:
• If you still cannot select the ignition
modes, there may be some problem with
the keyless push start system. Contact
an authorised Maruti Suzuki workshop
for an inspection of the system.
• The immobilizer/keyless push start sys-
tem warning light will come on for about
5 seconds while the master warning indi-
cator light is blinking. In addition, the
information display in the instrument
cluster will show a message during this
time. Refer to "Information Display" in
the "BEFORE DRIVING" section for
details.
• You may customize the system to cause
the interior buzzer to sound once for the
remote controller out of sensing range
warning. To incorporate this customiza-
tion, please contact an authorised Maruti
Suzuki workshop.
• If the battery of the remote controller is
about to become completely discharged,
the corresponding message will appear
on the information display when you
press the engine switch to change the
ignition mode to ON. Refer to "Informa-
tion Display" in the "BEFORE DRIVING"
section for details. For details on replac-
ing the battery, refer to the "Keyless
ON
Push Start System Remote Controller" in
the "BEFORE DRIVING" section.
REMOTE CONTROLLER OUTSIDE
Warning
When either of the conditions described
below is met, the system issues the
REMOTE CONTROLLER OUTSIDE warn-
ing by sounding the interior and exterior
buzzers. At the same time, the immobi-
lizer/keyless push start system warning
light comes on and the master warning
indicator light blinks.
• Any door is opened and then closed
while the remote controller is not inside
the vehicle and the engine is running or
the ignition mode has been changed to
"ACC" or "ON" by pressing the engine
switch.
• The remote controller is not inside the
vehicle when you attempt to start the
engine after changing the ignition mode
to "ACC" or "ON" by pressing the engine
switch.
(2)
EXAMPLE
(1)
61MM0A182
64MS0-74E
Advertisement
Table of Contents
