Table of Contents
Advertisement
BEFORE DRIVING
• Alarm
You can turn off or on the siren sound
when the door(s) is (are) locked or
unlocked.
Lights (Light setting)
• Foot Lights (Foot well lights setting)
(if equipped)
The foot well lights can be programmed for
interlocked operation with either lighting
control or door operation and for no light-
ing. (default setting is door operation)
• Lane Change (Turn signal lights set-
ting)
The turn signal and its indicator can be set
whether they flash three times even if you
return the turn signal control lever immedi-
ately after moving it. (default setting is
enabled state)
Anti theft
• Shock Sensor
You can switch the shock sensor from the
disabled state to the enabled state, and
vice versa. (default setting is disabled
state)
• Shock Sens P
You can adjust the pre-warning sensitivity of
shock sensor. (default setting level is 14)
• Shock Sens F
You can adjust the full blast warning sensi-
tivity of shock sensor. (default setting level
is 9)
2-53
IS A/C (ENG A-STOP system setting)
(if equipped)
• When using the automatic heating and
air conditioning system, you can select
one of the following engine auto stop
settings.
– Standard
– Economy
– Comfort
• When "Economy" is selected, engine
auto stop condition is eased, compared
with "Standard". Engine auto stop condi-
tion will occur more frequently, the stop
time will be longer, leading to reduction
of fuel consumption.
• When "Comfort" is selected, engine auto
stop condition becomes severe, com-
pared with "Standard". Engine auto stop
condition will occur less frequently, the
stop time will be shorter, leading to more
comfortable cabin condition by air condi-
tioner.
Default (initialization setting)
If you select "Yes" and push the indicator
selector knob (2), all settings will be reini-
tialized.
Warning and Indicator Messages
The display shows warning and indicator
messages to let you know about certain
vehicle problems.
A tone may also sound to alert you.
If warning and indicator messages appear
on the display, follow the messages.
Master warning indicator light
When the display shows warning and indicator
messages, the master warning indicator light
may also blink.
NOTE:
• When the problem that causes a mes-
sage to appear is corrected, the mes-
sage will disappear.
• If a message is displayed, and other
problems requiring a message occur, the
message for each of the problems will
be alternately displayed about every 5
seconds.
• When you push and hold the indicator
selector knob (2) for about 2 seconds
while a message is displayed, the mes-
sage will disappear temporarily. If the
problem that caused the message is not
corrected, the message will appear
again after 5 seconds.
64MS0-74E
78K049
Advertisement
Table of Contents
