Changing Wheels - MARUTI SUZUKI Celerio Manual

NOTICE
Never apply a garage jack to the
exhaust pipe, side under spoiler (if
equipped), engine undercover or rear
torsion beam.
NOTE:
For more details, please contact an autho-
rised Maruti Suzuki workshop.

Changing Wheels

WARNING
Never change a wheel in traffic lane.
Always move the vehicle off the road
on level, hard ground away from traf-
fic for changing a wheel. For any fur-
ther assistance contact your nearest
Maruti Suzuki authorised workshop.
To change a wheel, use the following pro-
cedure:
1) Clear all passengers and luggage from
the vehicle.
2) Remove the jack, tools and spare
wheel from the vehicle.
3) Loosen, but do not remove the wheel
nuts.
4) Jack up the vehicle.
CAUTION
Immediately after the vehicle has
been driven, the wheels, the wheel
nuts and the area around the brakes
might be extremely hot.
Touching these areas may cause
burn injury. Do not touch these areas
immediately after the vehicle has
been driven.
5) Remove the wheel nuts and wheel.
EMERGENCY SERVICE
6) Before installing the new wheel, clean
any mud or dirt off from the surface of
the wheel and hub with a clean cloth.
Clean the hub carefully; it may be hot
from driving.
7) Install the new wheel and replace the
wheel nuts with their cone shaped end
facing the wheel. Tighten each nut
snugly by hand until the wheel is
securely seated on the hub.
EXAMPLE
Loosen
Tighten
Tightening torque for wheel nut
85 Nm (8.7 kg-m, 62.7 lb-ft)
8) Lower the jack and fully tighten the nuts
in a crisscross fashion with a wrench as
shown in the illustration.
76MH1-74E
54G116
8-4