Automatically Stopping The Engine - MARUTI SUZUKI S-Cross Owner's Manual

Suzuki sx4 s-cross
Hide thumbs Also See for S-Cross:
Table of Contents

Advertisement

OPERATING YOUR VEHICLE
WARNING
• Do not go out of the vehicle when
the engine is stopped by the ENG
A-STOP system. If the driver's seat
belt is unfastened and the driver's
door is opened, the engine will
stall.
• When the engine does not restart
automatically even if you operate
vehicle properly, start the engine
using the ignition switch or engine
switch.
– In such situation, stopping on the
road may result in rear collision.
– In case the vehicle moves, the
steering and braking operation
will require more efforts, since
the engine is turned off.
NOTICE
Only use the vehicle battery type
(Exide conservo DIN70) that has been
approved by MARUTI SUZUKi, other-
wise you would damage your vehicle,
and the ENG A-STOP system could
not be available. If a vehicle battery
has to be replaced, consult your
authorised Maruti Suzuki workshop.
3-17
The ENG A-STOP system is automatically
activated when the ignition switch is turned
to the "ON" position or the engine switch is
pressed to change the ignition mode to
"ON".
The system activation also requires the fol-
lowing conditions:
• Driver's seat belt is fastened.
• Driver's door is closed.
• Engine hood is closed.
For more details, refer to the explanation
below.

Automatically Stopping the Engine

1) With the clutch pedal fully depressed,
stop the vehicle.
EXAMPLE
64MM03003
2) While depressing the brake and clutch
pedal, place the gearshift lever in the
"N" (Neutral) position.
EXAMPLE
64MM03004
3) Release the clutch pedal.
The "ENG A-STOP" indicator light
(green) (1) in the instrument cluster will
illuminate and the engine will stop auto-
matically.
NOTICE
The brake booster becomes inoperative
and the pedal effort will increase when
the engine is stopped automatically.
If the vehicle is moving, press down
the brake pedal harder than usual.
NOTE:
The ENG A-STOP system will not operate
and engine does not stop automatically
under the following conditions:
• The "ENG A-STOP OFF" switch is
pressed to deactivate the ENG A-STOP
system.
• The "ENG A-STOP OFF" light blinks.
64MS0-74E
(1)

Advertisement

Table of Contents
loading

Table of Contents