Yealink W60P Administrator's Manual page 340

Administrator's Guide for W60P DECT IP Phones
multicast.paging_address.X.channel
(X ranges from 1 to 31)
Description:
Configures the channel of the multicast paging group in the paging list.
If it is set to 0, all the Yealink DECT IP phones running firmware version 80 or prior or
Yealink DECT IP phones listens to channel 0 or third-party available devices (e.g., Cisco
DECT IP phones) in the paging group can receive the RTP stream.
If it is set to 1 to 25, the Polycom or Yealink DECT IP phones preconfigured to listen to the
channel can receive the RTP stream.
It it is set to 26 to 30, the Yealink DECT IP phones preconfigured to listen to the channel
can receive the RTP stream.
Example:
multicast.paging_address.1.channel = 3
multicast.paging_address.2.channel = 5
Web User Interface:
Directory->Multicast IP->Paging List->Channel
Handset User Interface:
None
To configure a codec for multicast paging via web user interface:
Click on Features->General Information.
1.
Select the desired codec from the pull-down list of Multicast Codec.
2.
320
Parameters Permitted Values
Integer from 0 to 30
Default
0