Initialization Process Overview - Yealink W60P Administrator's Manual

To register a new handset manually:
When the handset LCD screen prompts "Press base page 2s then press Reg.", long press
on the base station till the registration LED flashes.
Easy Registration:
Press the Reg soft key on the handset to register quickly.
1.
Normal Registration:
Press the OK soft key on the handset, and then select Register Handset.
1.
Select the desired base and then press the OK soft key. The handset begins searching the
2.
base.
Press the OK soft key after searching a base successfully.
3.
Enter the base PIN (default: 0000), and then press the Done soft key to complete
4.
registration.
After the success of registration, the handset LCD screen prompts "Handset Subscribed" and
"Base NO. (The last 4 characters of connected Base's MAC address)".
After initializing data successfully, an icon with internal handset number and handset name
appears on the LCD screen.
To register to multiple base stations:
Press the OK key to enter the main menu.
1.
Select Settings->Registration->Register Handset.
2.
Repeat steps 2-4 mentioned in normal registration to register multiple base stations.
3.
You can also enable the registration mode of the base station via web user interface at the path
Status->Handset&VoIP->Register New Handsets.
If the handset LCD screen prompts "Searching for Base", please check if your base station is
Note
powered on.

Initialization Process Overview

The initialization process of the DECT IP phone is responsible for network connectivity and
operation of the DECT IP phone in your local network.
Once you connect your DECT IP phone to the network and to an electrical supply, the DECT IP
phone begins its initialization process.
During the initialization process, the following events take place:
Loading the ROM file
The ROM file resides in the flash memory of the DECT IP phone. The DECT IP phone comes
from the factory with a ROM file preloaded. During initialization, the DECT IP phone runs a
bootstrap loader that loads and executes the ROM file.
Getting Started
9