Table of Contents
Advertisement
S5-115U Manual
Possible Configurations on Mounting Rack CR 700-0 (6ES5 700-0LB11)
You can use adapter casings with two printed-circuit boards in the case of the CR 700-0
(6ES5 700-0BL11) in contrast to the CR 700-0 (6ES5 700-0LA12). There are also slots for a power
supply module (PS), a central processing unit (CPU), block type digital/analog modules, intelligent
input/output modules and communications processors (CPs).
Mounting Rack
CR 700-0LB11
Slots
1
Power Supply Module
Central Controller
2
Digital Module
2
Analog Module
CP 513/523/524/525/552-1
CP 526/527 Basic Board
CP 581/CP 526 Expansion Board
CP 530-7
CP 5430
CP 552-2
CP 535-3MA12/CP 143-0AB01
IP 241/245/252
IP240/242
244/246/247/260/261
...
WF 625/725/470
DIMOS-VISRAM
IM 304/307/308
AS 301/302
5
IM 305/306
6
IM 307
Only with adapter casing
1 Use of the IP 246/247 and the CP 513/524/525/526/527/539/143 is not permissible with a 3 A power supply module
(the DSI signal is not generated from the 3 A power supply)
2 Digital/analog modules of ES 902 design (S5-135/155U) can be plugged into slot 0 to 2; block-type modules can be
plugged into slot 1 and 2
3 Can only be used in the lefthand slot when operating without fan
4 Slot cannot be used because of double-width module
5 Do not remove the terminating connector if neither the IM 305 nor IM 306 interface module is plugged in
6 Interrupt processing is not possible in slot 3
Figure 3-3. Possible Configurations on Mounting Rack CR 700-0 (6ES5 700-0LB11)
EWA 4NEB 811 6130-02b
PS
CPU
0
1
3
4
4
4
Installation Guidelines
2
3
IM
3-3
Advertisement
Table of Contents
