Table of Contents
Advertisement
3.5
Flow of Creating Registration Marks to Cutting
The flow from creating the registration marks using the dedicated application to cutting the plot is explained in
this chapter.
Graphtec Pro Studio
[1] Creating the registration marks
1.
Using the "Rectangle" tool in Graphtec Pro Studio, create a rectangle over
the design.
A margin is required at the edge of the media when creating the rectangle.
As the printing position may vary depending on the printer used to print
the design, it is recommended that a few extra millimeters be allowed for
the margin.
2.
Select the rectangle, and then select "Effects" – " Rectangle to Contour
Cut Mark...".
3.
On the "Design Central" screen, select the type of registration mark.
4.
Click the "Options".
The "Graphtec Mark Options" screen
will appear where you can specify
the length and line thickness of the
registration marks.
After specifying each item, close the
screen.
5.
On the "Design Central" screen, click the
"
".
Registration marks will be created over the
design.
Chapter 3 Cutting along Printed Data
Y
X
Y
Registration Mark Type 1
Registration Mark Type 2
X
Margin
3-9
Advertisement
Table of Contents
