Precautions When Creating Data; Notes Regarding The Cutting Origin Position - GRAPHTEC CELITE-50 User Manual

2.6

Precautions when Creating Data

Notes regarding the Cutting Origin Position

The position of the cutting origin will vary depending on the settings for "Cutting Area". Create cutting data in
reference to the following:
Tilt correction: Enabled
Margin: Normal/Expanded
The cutting origin (0, 0) will always
be near the vertex of the media edge
regardless of the state in which the
margin has been set.
Y
Cutting Origin
X
•
As the area between the media edge
approximately 5 mm inward from the
edge is outside of the cutting area,
the media will not be cut in this area
even if cutting data exists.
•
For information on the cutting origin when scanning registration marks, refer to "3.3 Printing & Cutting upon
Scanning Registration Marks".
•
For information on how to change the cutting origin, refer to "4.6 Cutting upon Specifying Cutting Positions".
•
For information on how to change the tilt correction, refer to "3.2 Simple Printing & Cutting".
•
For information on how to change the margin settings, refer to "4.7 Expanding the Cutting Area".
Tilt correction: Disabled
Margin: Normal
The cutting origin (0, 0) will be the
vertex of the effective cutting area.
The point approximately 5 mm inward
from the front edge and approximately
10 mm from the left edge.
Y
X
Approx. 5 mm
Cutting
Origin
Approx.
10 mm
Chapter 2 Basic Operations
Tilt correction: Disabled
Margin: Expanded
The cutting origin (0, 0) will be the
vertex of the effective cutting area.
The point approximately 5 mm inward
from the front edge and the left edge.
Y
Cutting
X
Approx. 5 mm
Origin
Approx. 5 mm
2-11