Table of Contents
Advertisement
6.
Measure by how much the registration mark for comparison is displaced from the registration mark for
correction.
Measure the distance between the center of each line.
In the case of the image on the bottom in Step 5, the correction needs to be made in the negative
direction for both X and Y so the correction values for each will be a negative value.
7.
Touch the "ADJUST X".
8.
Input the value of X measured in Step 5.
Use the " " and " " to select the setting value and confirm the
selection with the
9.
Similarly input "ADJUST Y".
Adjusting after Cutting the Test Pattern (Registration Mark for Correction)
Plot a registration mark for adjustment of the registration mark position and make the adjustment using this
registration mark.
1.
Load white media for cutting.
2.
Set a drawing pen in the tool holder and select a CONDITION NO.
3.
From the "MENU" screen, open the "ARMS
2/2" screen.
4.
Touch the "SENSOR OFFSET ADJ.".
5.
Touch the "TEST PATTERN".
6.
Move to the registration mark cutting position by using the " "
" " " " and " ". When the
mark for correction will be plotted.
CAUTION
When the "OK" is touched, the media and pen carriage will
start moving. Be careful to avoid contact with your body or any
object.
(Confirm).
(OK) is touched, the registration
Chapter 5 Detailed Settings
5-17
Advertisement
Table of Contents
