Loading And Scanning Roll Media - GRAPHTEC CELITE-50 User Manual

Chapter 4 Convenient Functions

Loading and Scanning Roll Media

There are two types of ways to load roll media with this device.
ROLL START EDGE
Use this option if you wish to cut from the edge of the roll media. The width and the leading
edge of the roll media will be scanned.
ROLL CURRENT POSITION
Use this option if you wish to cut from the middle of the roll media. Only the width of the
roll media will be scanned.
Loading the Media Up Against the Push Rollers
When loading the roll media up against the push rollers, the detection method will be "ROLL START EDGE".
1.
Raise the media set levers on both sides and release the push rollers.
2.
Set the push roller on the left side at the position of the "
Set the push roller on the right side according to the width of the roll media.
3.
Lower the media set levers on both sides and lock the push rollers.
4.
Pull out the roll media and create slack in the roll media that is the same amount as the length used at
the front of the main unit.
5.
Press "LOAD MEDIA" on the "HOME" screen, and select "ROLL
START EDGE".
4-4
Create slack equivalent to
length being used
" mark.