GRAPHTEC CELITE-50 User Manual page 57

6.
Evenly position the leading edge of the roll media up against the push rollers.
Pass the roll media under the push roller positioning guide and load it so that it is parallel with the Front
front guide.
Push Roller
Front Guide
Set to be parallel
7.
Align the left edge of the roll media with the "I" marking of the "
Front Guide
8.
The roll media is set after detecting the width and leading edge.
Operate the device by following the on-screen instructions when an error message appears.
CAUTION
When the "ROLL START EDGE" is touched, the media and tool carriage will start moving. Be careful to
avoid contact with your body or any object.
Leading Edge of Roll Media
Leading Edge of Roll Media
Push Roller
Roll Media
Roll Media
Roll Media Marking
Chapter 4 Convenient Functions
Push Roller
" mark on the front guide.
Roll Media
4-5