Loading Sheet Media; Loading The Media Up Against The Push Rollers - GRAPHTEC CELITE-50 User Manual

Chapter 2 Basic Operations
2.4

Loading Sheet Media

Use the standard media size of sheet media. Use the carrier sheet when using the non standard media size of
sheet media.
•
Depending on the type of media (especially with high transparency), the media cannot be set because CE
LITE-50 cannot detect the leading edge /width /position of the media. In this case, use a carrier sheet or
disable the Media width detection.
•
Depending on the type of media, the center of the media may be lifted up because the push rollers cannot
hold down the media sufficiently. In this case, move the Media holding rollers (movable) to the position where
the media is lifted up. When the media is load flat, move them to the right push roller.
•
Move the Media holding rollers (movable) after raising the Media set levers.
•
Limp or too much thin media cannot be cut.
For more information on the carrier sheet, refer to "4.2 Cutting using the Carrier Sheet".
For more information on the media width detection, refer to "5.7 Setting the Media Width Detection".
Supported sheet media size: A4 - 20inch (refer to "1.5 Media Size and Cutting Area")

Loading the Media Up Against the Push Rollers

1.
Raise the media set levers and release the push rollers.
2.
Set the push roller on the left side at the position of the "
Set the push roller on the right side according to the width of the sheet media.
3.
Lower the media set levers on both sides to lock the push rollers.
4.
On the "HOME" screen, touch the "LOAD MEDIA" − "SHEET".
2-6
" mark.