Table of Contents
Advertisement
Chapter 4 Convenient Functions
Setting the Page Length
When using roll media, set the length of a single page.
•
The default setting value is 50 cm. Confirm the setting for the page length when cutting a long item.
•
If the cutting data exceeds the page length that has been set, only the parts within the set area will be cutted
and anything outside of this area will not be cutted.
•
This device guarantees page feeding precision for up to 100 cm (when using media and setting conditions
specified by Graphtec).
•
When loading media to cut a long item, load the media so that the tension is even at both sides in the
direction of the media's width. If the tension is uneven, the media may slip out from under the rollers holding
the media in place while cutting.
Once you are done with the setting, touch the
Setting values: 10 - 300 (cm)
1.
From the "MENU" screen, select "MEDIA
1/3" and proceed to the "MEDIA 2/3"
screen.
2.
Touch the input box for "PAGE LENGTH".
3.
Input the page length and confirm the input with the
4-8
(Exit) to return to the "HOME" screen.
(Confirm).
Advertisement
Table of Contents
