Performing Cut Tests; Cutting 1 Test With The Setting Values - GRAPHTEC CELITE-50 User Manual

5.5

Performing Cut Tests

Confirm the quality of the cut with the setting values of the CONDITION NO. (cutting condition) by looking at
how nicely the media has been cut and the rounding of corners.
1 PIECE: One "
" mark (test pattern) will be cut using the setting values of the currently displayed
CONDITION NO.
3 PIECES: Three "
" marks (test patterns) will be cut using the setting values of the currently displayed
CONDITION NO. as well as a cutting force or cutter offset value that is one less than or higher than
the setting values.

Cutting 1 Test with the Setting Values

1.
Set the same media and tool as the actual cut.
2.
On the "HOME" screen, use the " " and " " to select the
CONDITION NO. to perform the cut test with and touch the
(CUT TEST) to open the setting screen.
3.
Select the "1 PIECES" for the cut test.
Use the " ", " ", " " and " " to move the tool to the cut
starting position and touch the
CAUTION
When the "OK" is touched, the media and tool carriage will start moving. Be careful to avoid contact with
your body or any object.
(OK) to cut one " " mark.
Chapter 5 Detailed Settings
5-11