Notes Regarding The Cutting Area - GRAPHTEC CELITE-50 User Manual

Chapter 2 Basic Operations

Notes regarding the Cutting Area

The cutting area will vary depending on the media and the settings for "Cutting Area". Create cutting data in
reference to the following:
Media: Sheet media
Tilt correction: Enabled/Disabled, Margin: Normal
Front Edge: 5 mm / Left/Right: 10 mm / Rear Edge: 30 mm
Media: Carrier sheet
Margin: Normal/Expanded
Front Edge: 5 mm / Left/Right: 5 mm / Rear Edge: 5 mm
•
For information on how to change the margin settings, refer to "4.7 Expanding the Cutting Area".
•
For more information on the carrier sheet, refer to "4.2 Cutting using the Carrier Sheet".
2-12
Y
5mm
X
Cutting Area
30mm
10mm 10mm
Y
5mm
X
Cutting Area
5mm
5mm 5mm
Media: Sheet media
Tilt correction: Enabled/Disabled, Margin: Expanded
Front Edge: 5 mm / Left/Right: 5 mm / Rear Edge: 30 mm
Y
X
Cutting Area
5mm
5mm
30mm
5mm