Table of Contents
Advertisement
Chapter 5 Detailed Settings
7.
Touch the "SCAN".
8.
Use the " ", " ", " " and " " to move the tool to the
registration mark scan starting area and touch the
Scan the registration mark and then plot a registration mark to use for comparison.
9.
Measure by how much the registration mark for comparison is displaced from the registration mark for
correction.
Measure the distance between the center of each line.
In the case of the image on the bottom in Step 8, the correction needs to be made in the negative
direction for both X and Y so the correction values for each will be a negative value.
10.
Touch the "ADJUST X".
11.
Input the value of X measured in Step 8.
Use the " " and " " to select the setting value and confirm the
selection with the
12.
Similarly input "ADJUST Y".
5-18
Y
Registration Mark
X
Scan Starting Area
Registration Mark
for Correction
Registration Mark
Y
for Correction
Distance Adjustment
X
Value X
Registration Mark
for Comparison
Distance
Adjustment Value Y
(Confirm).
(OK).
CAUTION
When the "OK" is touched, the media
and pen carriage will start moving.
Be careful to avoid contact with your
body or any object.
Advertisement
Table of Contents
