Arms Errors; Other Error Displays - GRAPHTEC CELITE-50 User Manual

Chapter 6 Troubleshooting
Error No.
E03011 An invalid byte was received following an ESC code.
Error 11
E03012 An invalid byte was received amongst device control
Error 12 orders.
E03013 A parameter outside of the acceptable range was
Error 13 specified for an I/O related command.
E03014 There are too many parameters for an I/O related
Error 14 command.

ARMS Errors

Error No.
E04001 The tilt set with axis alignment is too large.
The configurable range for distance adjustment has
E04002
been exceeded.
E04003 Sensor level adjustment failed.
The configurable range for distance adjustment has
E04004
been exceeded.
E04005 Registration marks could not be scanned.
The data volume exceeded the I/O buffer with
E04006
segment area registration marks.
The test pattern cutting position is not fully contained
E04007
in the cutting area with sensor position adjustment.
The end of the media was scanned while scanning
E04008
the registration marks.
E04009 The search range was exceeded while scanning the
to E04017 registration marks.
E04018 The media set lever was raised.
E04019 The cancel operation was performed by the user.
E04020 There is an error with the scan setting values.
Registration marks could not be found within the
E04021
automatic scanning range.
E04022 The cancel operation was performed by the user.
E04023
Registration marks could not be scanned.
to E04025

Other Error Displays

Error No.
E01001
Failure of the device.
to E01015
E05001 Data larger than the buffer size cannot be copied.
E05002 There is no data to copy.
E05003 The available area on the media to copy is too small.
6-4
Displayed
Cause
Cause
Solution
Check the program.
Check the program.
Check the program.
Check the program.
Solution
Reload the media.
Set a smaller distance adjustment value.
That particular media cannot be used.
Set a smaller distance adjustment value.
Confirm the registration mark scanning positions.
Reduce the amount of data.
Plot the test pattern upon moving the media more
towards the center.
Confirm the media.
Review the positions where the registration marks are
printed.
Confirm the media.
Review the positions where the registration marks are
printed.
Reload the media and try again.
Redo the process.
Review the setting values.
Confirm the media.
Review the positions where the registration marks are
printed.
Redo the process.
Readjust the sensor levels.
Change the color used to print the registration marks.
Confirm the media.
Review the positions where the registration marks are
printed.
Solution
Contact the store of purchase or our company's
customer service.
Cut the data normally without using the copy mode.
Send data, perform normal cutting, and then use the
copy mode.
Use a larger media.
Confirm the copy starting position.