Auto Connect - KoamTac KDC20 User Manual

KDC User Manual
The user may also enable and disable the iPhone and iPad soft keyboard instantly by
using this BT Toggle option in HID mode.
The UP button shows the Bluetooth connection status and the DOWN button shows the
time when this option is disabled.
The user should first un-pair the KDC from the Bluetooth host to change the
Note
Connect Device setting on the scanner to a different Bluetooth profile.

Auto Connect

This feature enables the KDC to automatically connect to the host device when the
KDC is powered on. KDC500 doesn't support Auto Connect.
IMPORTANT: Until the host device and the KDC have been fully tested, it is strongly
recommended that this feature be set to 'Disabled', because a host device that does not
support this feature could cause problems, such as power loss or upload delays.
The KDC automatically tries to connect to the host 10 times within the
Note
duration of two minutes when
disconnected, Auto Connect is enabled, and system Sleep Timeout is set
to 5 seconds.
Auto Reconnect
This feature enables the KDC to automatically connect to the host device when the
KDC is disconnected from a host.
The KDC tries to connect automatically to the host 10 times within the
Note
duration of two minutes if Bluetooth is disconnected.
Auto Power On
The Auto Power On option Enables the KDC to automatically power on Bluetooth
when the SCAN button is pressed. The default setting is Disabled. KDC500 doesn't
support this option.
Users should press the scan button for the duration defined in the BT Config
Note
Power-on time option. The host program may have to open the COM port
again in order to be reconnected with the KDC.
PWR ON Time
The PWR On Time option works in conjunction with the Auto Power On option. The
default value is Disabled. If the KDC Bluetooth power is off, you may turn on the
Bluetooth
power is ON,
B
LUETOOTH
Bluetooth
is
111